Nanusens goes smaller and creates nano-sensors in standard CMOS

electronicspecifier | Posted: 08 Aug 2017, 14:09

Nanusens has announced that its CMOS nano-sensor technology has been successfully used to solve the problem of stiction in MEMS inertial sensors, which is a major source of failure for this type of sensor. "Our first silicon nano-sensor samples from GLOBALFOUNDRIES exceeded our expectations showing outstanding resilience to stiction, with the devices going through more than 10,000 switching cycles, each equivalent to more than 1000G shocks," explained Nanusens' CEO, Dr Josep Montanyà i Silvestre.
Nanusens goes smaller and creates nano-sensors in standard CMOS
 
"And the sensitivity is an order of magnitude above what is needed for a motion sensor in most applications." The problem of stiction in MEMS is caused by attractive forces that occur on microscopic levels such as Van der Waals and Casimir. These are surface area dependant and not mass dependant.
 
In an inertial sensor design, there is a proof mass connected to a spring. This mass moves when there is an acceleration and the movement is detected by the mass acting as one electrode and the change in capacitance is measured relative to a second fixed electrode.
 
However, if there is a large movement such as from a shock or collision, the mass goes beyond the normal range of travelling and touches a surface enclosing the sensor where it 'sticks' due to the attractive forces and stops working.
 
This can be countered by having stronger springs but this reduces the sensitivity of the sensor. A solution to increase the sensitivity could be to increase the mass but this results in a greater surface area for the mass and so, unfortunately, more attractive forces.
 
The approach used by Nanusens is to reduce the sensor design by an order of magnitude from Micro ElectroMechanical Systems (MEMS) with linear feature sizes of 1-2um to Nano ElectroMechanical Systems (NEMS) where the features are 0.3um.
 
This reduces the attractive forces significantly as the surface area reduction is in two dimensions, i.e. almost two orders of magnitude reduction. Reducing the proof mass could result in decreased sensitivity except this is offset by reducing the gap between it and the fixed electrode.
 
The size reduction also means that the energy stored on the proof mass when it hits the surface in case of a shock, it is much less and the travelling gap is also small. A shock with less energy is also easier to detach.
 
"Therefore, by reducing all the dimensions of the device, we keep the sensitivity and we increase the reliability," added Dr Montanyà. "In fact, we have such a gain in reliability, that we can increase sensitivity and still have a very reliable device."
 
The new nano-sensors are made using standard CMOS processes and mask techniques. The Inter Metal Dielectric (IMD) is etched away through the pad openings in the passivation layer using vapour HF (vHF) to create the nano-sensor structures.
 
The holes are then sealed and the chip packaged as necessary. As only standard CMOS processes are used, and the sensors can be directly integrated with active circuitry as required, the sensors can potentially have high yields similar to CMOS devices.
 
Nanusens has perfected this CMOS nano-sensor technology over the past year based on developments that the key staff had done when working at Baolab Microsystems, which closed in 2014. It was the success of this previous work that has enabled Nanusens to partner with GLOBALFOUNDRIES (GF).
 
Rajesh Nair, vice president of product management at GF, commented, "We have built a strong relationship with Nanusens and we look forward to advance this new generation of sensor designs using our standard 0.18um processes."
 
Dr Montanyà concluded, "Nanusens decided to partner with GF to develop its nano-sensors due to the outstanding technical expertise and quality of service received from their teams, together with such a large variety of CMOS nodes where we plan to move some of the devices in the future including many RF options".
 
"In addition to this, producing our nano-sensors at GF, with their huge volume capacities that keep growing due to their continuous investment in their global footprint ensures that Nanusens will have all the required production capacity that it will need in the future, and that there will never be a shortage in supplying our products to the customers. This large volume capacity is key to serve the consumer market, where demand can fluctuate very quickly, and there can be unexpected peaks."

Electronics

Current sensor IC with dual fault user settable

Current sensor IC with dual fault user settable

Allegro MicroSystems Europe has introduced a new high accuracy Hall-effect-based current sensor IC with multiple programmable fault levels intended for industrial and consumer applications with a focus on motor control and power inverter stage applications.

Metal foil chip resistors support 1-30A applications

Metal foil chip resistors support 1-30A applications

Global provider of engineered electronics for performance critical applications, TT Electronics, has extended its MFC series of metal foil chip resistors with a new 2817 size that can dissipate up to 3W.

Test cables deliver high performance, phase stable results

Test cables deliver high performance, phase stable results

Amphenol RF has introduced the ATC-PS series of amplitude and phase stable test cables.

Cable assemblies target range of applications

Cable assemblies target range of applications

A number of pre-prepared cable assemblies that provide compatible solutions for key product ranges from Molex are now available at distributor RS Components.

Power limiter delivers reliable, repeatable protection

Power limiter delivers reliable, repeatable protection

Availability and full design support capabilities for a power limiter from Peregrine Semiconductor have been announced by Richardson RFPD.

Memory sub-system combines NOR flash with self-refresh DRAM

Memory sub-system combines NOR flash with self-refresh DRAM

The S71KL512SC0 HyperFlash and HyperRAM Multi-Chip Package (MCP) from Cypress Semiconductor is available at Mouser Electronics.

Evaluation kit is based on a 300K logic element FPGA

Evaluation kit is based on a 300K logic element FPGA

The PolarFire Evaluation Kit from Microsemi, which allows designers to evaluate the PolarFire FPGA product family is now being shipped by distributor Mouser Electronics.

M12 connectors can handle up to 16A

M12 connectors can handle up to 16A

binder just announced a field assembly M12 connector designed for power handling applications across many industrial sectors where, according to the company, the adoption of automation technology is becoming widespread.

Industrial Micro SD cards conform to SD 3.0 specifications

Industrial Micro SD cards conform to SD 3.0 specifications

In response to the growth trend of mobile and wearable devices, memory manufacturer Apacer has launched industrial Micro SD/Micro SDHC memory cards which conform to SD 3.0 specifications.

Coaxial Cable 4.0 supports UV-cured lining systems

Coaxial Cable 4.0 supports UV-cured lining systems

Able to withstand extremely harsh environments and high mechanical loads the cable was designed for an above-average service life, while its small outer diameter of only 22 mm belies the sophisticated engineering of the cable.

Ultrafast RF MOSFET driver has high peak output current

Ultrafast RF MOSFET driver has high peak output current

IXYS Corporation a power semiconductors, mixed-signal and digital ICs for power conversion and motion control applications company has announced the introduction of the IXRFD615 ultrafast low-side RF MOSFET gate driver by its IXYS Colorado division.

Mini encapsulated AC/DC power modules approved for households

Mini encapsulated AC/DC power modules approved for households

The new 3W AAF-03 and 5W AAF-05 families of ultra-miniature encapsulated power module in a 1x1x0.64” PCB Mount package has been introduced by MINMAX.

SiC MOSFETs enables power supplies to achieve titanium efficiency

SiC MOSFETs enables power supplies to achieve titanium efficiency

Wolfspeed, supplier of silicon carbide (SiC) power products has advanced the development of high efficiency data centre power supplies through the implementation of an innovative totem-pole PFC topology that employs its latest low-inductance SiC MOSFETs to exceed an 80+ Titanium rating.

RF synthesiser saves MIMO, beamforming design time

RF synthesiser saves MIMO, beamforming design time

The LMX2594 wideband PLLatinum radio frequency (RF) synthesiser from Texas Instruments (TI) is now being shipped by Mouser Electronics.

Maintenance-free conductor clamps provide contacts in no time

Maintenance-free conductor clamps provide contacts in no time

When manufacturing control gear and switchgear systems, wires and cables routinely have to be connected to copper busbars.

Automation

Give the dog a drone and you'll get hands-free walkies

Give the dog a drone and you'll get hands-free walkies

Dog lovers can now add a touch of technology to walkies, following the launch of a new revolutionary dog drone. The DJI Phantom 4 Dog Drone, which can be purchased from drones e-tailer, DronesDirect.co.uk, is a useful tool for walking those pampered pooches.

CCTV drones - coming to a neighbourhood near you

CCTV drones - coming to a neighbourhood near you

Drones have been the future technology to watch for the past few years, and according to CCTV.co.uk it looks like we’re still not done thinking about their potential.

Wireless sensor hardware and connectivity make IoT easy

Wireless sensor hardware and connectivity make IoT easy

Identified system integrators and services provides have been deemed as having the greatest opportunity of all company types to deploy, use and generate revenue from IoT/M2M applications, according to LPRS CS.

Field Spectroradiometer

Field Spectroradiometer

The PSR+ field spectroradiometer from Spectral Evolution measures soil organic carbon, providing critical information on soil fertility, aggregate stability and the exchange of CO2 with the atmosphere.

Sensors support wide-distance object detection at low power

Sensors support wide-distance object detection at low power

Two ultrasonic signal processors and drivers, the PGA460 and PGA460-Q1, from Texas Instruments (TI) are now being shipped by distributor Mouser Electronics.

Integrated Circuit Sensor

Integrated Circuit Sensor

The TCS3430 XYZ tristimulus True Color integrated circuit sensor from Ams AG is offered with a small footprint suitable for consumer devices such as notebooks, smartphones and tablets.

Machine Vision Camera

Machine Vision Camera

The EoSens 3FIBER high-speed machine vision camera from Mikrotron GmbH features fiber interface and combines high data rates with cable lengths up to 300 m.

Differential Measurement Systems

Differential Measurement Systems

The KD-5100 differential measurement system from Kama Precision Products Inc. provides resolution to a nanometer of positional change.

CMOS Cameras

CMOS Cameras

The Baumer Group has announced the CX models of Sony Pregius CMOS cameras with a 1-µs exposure time.

Rigid Photomacrography System

Rigid Photomacrography System

The Macropod PETROGRAPHIC from Macroscopic Solutions LLC is a rigid photomacrography system that allows slides or thin sections to be imaged and analyzed in plain light and cross polarized light.

Holographic Microscope

Holographic Microscope

The HT-2 holographic microscope from Tomocube Inc. displays both 3D holograms and 3D fluorescence imaging.

BX53 Microscope

BX53 Microscope

The BX53 microscope from Olympus Europa SE & Co. KG provides bright, sharp images with excellent color rendering performance equivalent to halogen lamps.

Spectrometer

Spectrometer

The Progeny ResQ analyzer from Rigaku Analytical Devices Inc. is a spectrometer for first responders.

Image Sensor

Image Sensor

An RGB-IR version of the ON Semiconductor AR0237 image sensor has been announced by Framos GmbH and is designed for applications needing both visible and NIR light.

Smart IR Thermal Imaging Camera

Smart IR Thermal Imaging Camera

The EyeCheck Thermo IR Camera from EVT Eye Vision Technology GmbH is a smart thermal imaging camera with EyeVision Thermo software.

IQE's strong first-half revenue growth

Epiwafer foundry and substrate maker IQE plc of Cardiff, Wales, UK says that, for...

Global semiconductor revenues to pass

Worldwide semiconductor revenue are expected to pass USD 400 billion for the first time...

NAURA New Energy to launch new coater

NAURA New Energy to launch new coater and all-in-one for slitting and calender

NAURA New Energy, a leading lithium battery equipment supplier, has developed online...

Fujitsu, SAP expand global partnership

Fujitsu and SAP has expanded their global partnership to offer advanced ERP solutions...

11111